IMX477 Camera will not boot on Orin Nano

Nvidia Jetson Nano/NX Cameras
1

  1. Where did you get the camera module(s)?
    Amazon

  2. Model number of the product(s)?
    UC-698 Rev D & UC-517 Rev D3

  3. What hardware/platform were you working on?
    Jetson Orin Nano Development Board 8GB.

  4. Instructions you have followed. (link/manual/etc.)
    N/A wont boot.

  5. Problems you were having?
    N/A Wont boot.

  6. The dmesg log from your hardware?
    N/A Wont boot.

  7. Troubleshooting attempts you’ve made?

  8. What help do you need?

IMX477 should be natively supported on my hardware. Will not boot with correct CSI cable.

2

I have emailed and posted here. Been waiting for days for a response. I have 2 B0273 Cameras. They are listed at the link below as compatible with the Orin Nano. Despite this, the board will not boot with either camera attached. A response would be appreciated.

https://docs.arducam.com/Nvidia-Jetson-Camera/Nvidia-Jetson-Orin/Introduction/

3

@Steve

Please give detailed information, which step did you make an error, and what command did you execute before the error?

Also please tell me your system information and hardware connection.