Requirement of Adapter board

  1. Where did you get the camera module(s)?
  • we received from our client
  1. Model number of the product(s)?
  • OV5647
  1. What hardware/platform were you working on?
    Jetson Nano/Nx - L4T version - 32.5.1

  2. Instructions you have followed. (link/manual/etc.)
    1. Camera Driver Installation - Arducam

  3. Problems you were having?
    Camera not detected. with command —ls/dev/video*

  4. The dmesg log from your hardware?

  5. Troubleshooting attempts you’ve made?
    yes - we tried

  6. What help do you need?
    2. Camera Demonstration - Arducam

  1. In this document , mentioned about “The Jetvariety adapter board” , is this require when connecting single camera module with jetson Nano/NX module.? if required can you share the link from for purchase.
  2. Is OV5647 Drivers support for jetson Nano/NX ?

@gagan.hm

I’m sorry that I took a long vacation.
Can you tell me the sku number of your camera or a link to buy it?I am referring to the ones you have purchased now.

hello Edward

we are checking with our client on SKU no, will update you soon on that.

Hello Edward

Client has purchased cameras from Amazon online platform. Below are the shared links

Amazon.com: Arducam 5MP Camera for Raspberry Pi, 1080P HD OV5647 Camera Module V1 for Pi 4, Raspberry Pi 3, 3B+, and Other A/B Series : Electronics

Amazon.com: Arducam CSI to HDMI Cable Extension Module with 15pin 60mm FPC Cable for Raspberry Pi Camera Specific (Pack of 2, 1 Set) : Electronics

I hope this information would be helpful.

@gagan.hm

This is required for the adapter board, the OV5647 does not work alone with the jetson.
I don’t make any product recommendations, you can contact [email protected] by email , with a link to your forum.