-
Where did you get the camera module(s)? Amazon
-
Model number of the product(s)? OV5642
-
What hardware/platform were you working on? Initially Pi…Later microcontroller/baremetal.
-
Instructions you have followed? online
-
Problems you were having?
The product description states, “Arducam mini not only offers the capability to add a camera interface which doesn’t have in some low cost microcontrollers, but also provides the capability to add multiple cameras to a single microcontroller.” Yet I can find no way to change the I2C address. So placing two of these devices on the same bus runs into a conflict. Is there a jumper, resistor, something I can change to shift the address on a second camera board. (This is the reason I purchased this specific camera. I should have dug thru the real documentation first.) -
The dmesg log from your hardware? NA
-
Troubleshooting attempts you’ve made? NA
-
What help do you need? To change the I2C address on a second camera.
Hello,
The i2c device address of the camera cannot be modified.