init camera status = 4099 on IMX298 (16 MP) ArduCAM running on Pi 4B 8GB

Hello,

It seems it does not have operation permission. Please use ‘sudo chmod +x camera_i2c’ to git the permission.

 

Thank you. I tried this and still had the same issue.

I have since tested the camera on a Pi Zero W and it worked fine after I installed the software according to the instructions. I have reinstalled all the software for the Pi 4B 8GB but still have the same problem.

 

Hi, I have the same issue with RPi4 8GB on Arducam OV9281. It worked fine on RPi4 4GB and but on RPi8GB I’m getting “init camera status = 4099” even after clean reinstallation and so on. Have you tested it on RPI4 8GB?

Hi,

I haven’t tested it on RPI4B 8G platform, Can you tell me the hardware platform’s version the demo print?

Maybe the driver does not add the version support. I can add it to try.

Sorry for my late reply due to our Dragon Boat Festival holiday.

Thank you, no problem.

I ran the cpuinfo command and got the following information that I think is what you are looking for. Please let me know if you need anything else.

Hardware: BCM2835

Revision: d03114

Model: Raspberry Pi 4 Model B Rev 1.4

 

Hi,

I have add the platform support just now. Please download new code to retry. Don’t forget to run make install to install the new lib.

https://github.com/ArduCAM/MIPI_Camera/tree/master/RPI

 

Let me know if you need more help.

Works for me!!! Thanks a lot for fast and accurate response.

Excellent, thank you. It’s working now.

You are welcome.

Let me know if you need more help.

 

Thank you, I will do. I am hoping the camera will be very useful.

Well,

Arducam will recommend the best camera solution based on customer’s application need.

Thank you. I did quite a lot of research before buying this one and expect it will do the job well now that it’s working.

OK.

Great,
If there is any need, please contact me in time.

Hello,

I’m experiencing the same issue on RPI 4B 4GB Rev. 1.4

Hardware: BCM2711

Revision: c03114

Could you please help?

Regards,

Jakub

Hello,

Of Course, I have updated the libarducam_mipicamera lib and you can download our latest lib to retry.

 

Thank you very much :slight_smile:

Hi,

You are welcome. Feel free to let me know if you need more help.

 

 

Hello,

I’m experiencing the same issue on RPI Compute Module4 with Official I/O Board.

My camera is AR1820HS.

When I runed camera_i2c script, message

setting GPIO for board revision: c3140

Failed: don’t know how to set GPIO for this board!

shown.

Hardware: BCM2711

Revision: c03114

Could you please help?

 

 

Hello,

We also have with a Pi4 (revision : c03114) with the same camera status=4099 error.

We are using the ov9281 camera modules.

is there a solution for this ?

w.r.

GJ