-
Where did you get the camera module(s)?
https://kamami.pl/ -
Model number of the product(s)?
two cameras ArduCAM B0250 -
What hardware/platform were you working on?
Forecr Carrier Board (dsboard-nx2) with Jetson Nano production module -
Instructions you have followed. (link/manual/etc.)
IMX477 - How to install the Driver - Arducam -
Problems you were having?
The camera for the first csi connect works fine but no video source is detected for the second connector. -
The dmesg log from your hardware?
[ 1.303648] imx477 7-001a: tegracam sensor driver:imx477_v2.0.6
[ 1.605293] imx477 8-001a: tegracam sensor driver:imx477_v2.0.6
[ 1.905633] imx477 8-001a: imx477_board_setup: error during i2c read probe (-121)
[ 1.913305] imx477 8-001a: board setup failed
[ 1.917773] imx477: probe of 8-001a failed with error -121
[ 2.194228] vi 54080000.vi: subdev imx477 7-001a bound -
What help do you need?
I have installed the Arducam drivers but at the end of installation an error pops up:
Nevertheless, the camera for one of the connectors works fine:
Do you have any information or guidance about using imx-477 sensors on both connectors?
Thank you in advance.
Best regards,