Breakout board for IMX321

Hi all! I have salvaged a sensor on an old Nikon D500 which got wet on the beach. I extracted the sensor and tried looking for a fix to make use of the sensor that’s why i found out about arducam.
My plan is to control the sensor via RPi. Is there a compatible breakout board for this sensor?
I wish there is still hope for the sensor since it looks like it was not affected by the corrosion. I also sent an inquiry to arducam for a customized board.

Is this possible? Thank you very much!

Thanks for your question,
For this kind of question the tech support team is hard to answer it, I think you need to contact [email protected]